A/B SuperCold Machine Parts

[geoffr]

Does anyone know where the part shown below can be bought? Due to a poor installation there has been some arcing and one of the screw terminals no longer works. I'd rather replace the whole PCB than try to remove and replace the terminal..

[Richard Kollmann]

The printed circuit board inside that box is a defective design best solution is to remove it or bypass it. See Tech Tip #1 on my web site. http://kollmannmarine.com/tip1.asiley spx.

This circuit board's printed copper power strip is easily damaged cracking copper when pressure is applied to positive or negative wire terminals. To check the positive side remove 15 amp fuse and see if fuse holder shows overheating. To check Ground end of board failure look in opening in back of stainless box at the board.

[Coolerking]

Richard is right, ditch that thing and wire it all direct.

[geoffr]

Richard - I was hoping you'd answer

Richard & CoolerKing - thanks for the reply - I have removed it and will be rewiring things.. scary and poor that they used a cheap PCB with layers and traces that are too thin for the current!