Looking for NAC-2/3 N2K data capture to make Raymarine AP work with B&G Vulcan/Zeus

[hanst]

I've got an Beneteau Oceanis 40 with Raymarine Tridata (ST60) sensors and a CW80 MFD. Recently I've added a B&G Triton2 and it's showing most of the data. It won't however show the AutoPilot info, and I want it to.
I also want to be able to control the AP from the b&G Vulcan 12" that I'm planning to install.

I've got a Raspbarry Pi now setup on the N2K network with SignalK on it and it can already do nice things. One of which is reading the Simarine Pico values over the network and insert them into SignalK which brings it to N2K.

My plan is now to capture the Raymarine communication PGNs and convert them to (simplfied) NAC-2/3 messages and by doing so fooling the B&G MFD and Triton2 into thinking 'it's one of them'.

Does anyone here have a NAC-2/3 with a B&G MFD who's able to capture some N2K traffic? Preferably during boot and then pressing buttons.

Cheers,

hans

[hanst]

Looking though the Triton2 firmware, it looks like it's looking for the AP controller, rather than the NAC-2/3. Like the Simrad AP44 Autopilot Controller.
I'll redo the post asking for a capture of that device.