Ray Marine Tri-Data

[Liam Wald]

I have a ray marine tri-data that is connected to ray marine wind speed/direction. It is about ten years old.
The boat speed/log and the wind speed readouts stopped working. They are getting power. Instead of numerals there is a straight line on the readouts. The depth and the wind direction work just fine.
When the problem first began it was intermittent and if I turned the unit off and on a couple of times it would start working. That action no longer will get it going again.
I really can't figure this one out and was hoping that someone here has had a similar issue and can advise before I hire a marine electronic tech.
Any advice or help with this would be greatly appreciated.
Thanks.

[BocaIII]

Raymarine has a excellent tech support forum with Raymarine techs responding to these type of questions.
Discussion Forum - Raymarine Technical Forum

Jack
W4GRJ

[galacticair]

Is both your apparent wind speed and true wind speed not working? If only true wind, it could be a problem isolated to your log transducer (e.g. connection error), since log BSP would normally feed into both your BSP and TWS data.

Either way, check the cable connections sounds like you might have a broken connection?