Raymarine ST60 repeater looses programing after power down

[CaptainRivet]

Hi all,
I have an raymarine ST60 repeater installed at the salon nav station. I have the phenomen that it only shows depth after powering it up. but after I reset it manually it works fine and show all the wind, SOG... data . When I power it down (just switch off the whole nav stuff) and then power the whole nav stuff up the ST60 repeater only shows depth again but no wind, SOG.... data at all. When i reset it manually all works fine again till i power it down.
How can i fix this?
Thank you

[OldGreyB]

The Raymarine ST60 with this issue apparently needs a firmware or physical repair. I had a link on this subject matter from the Raymarine Forum, but can not find it at this time to quote to you.

This is now legacy equipment and generally not supported by Raymarine Offical Technical shops.

However the ST60 is of the generation where the original design enables repairs. So from other CF threads we have learnt to contact the "Legacy Raymarine Equipment Whisperer", Dan Gerhardt. He operates an EBay store https://www.ebay.com/usr/kodiakjack99 for legacy products and also has a good reputation for legacy Raymarine repairs. The ebay link provides his email. We found him via a CF thread and this blog post:https://theboatgalley.com/raymarine-instrument-repair/ Definitely worth an email to Dan describing your faults and any fault finding to date.