ST6002 to EV1

[dazmacg]

Anyone connected these two with success? I am sure to think yes.
Installed new instruments including an Axiom Pro on my boat replacing a working ST50/St7000 set up.
I would like to use the AP ST6002 control as a repeater for AP control at the helm, what is the best way to connect?
I already have a converter set up to take my gps to an older version radar and keep that working.
A second option is easy to replace the 6002 with a new I70 but at £500 why not just add a smaller plotter for not much more?

[smac999]

The only way would be with the raymarine seatalk to seatalkng converter. Which it sounds like you may already have. Just join the whole seatalk bus to ng bus. I have no idea if it will work. It might. The old seatalk plotters can control the new pilots through the converter.

[Flod]

I have that setup and it works fine. As the previous poster states you need to connect the new seattalk ng (which is basically a nmea2000 network) to the old seatalk with a sealkng to sea talk converter. It’s plug and play.