OpenCPN and Garmin radar 18 HD+

[Hakan]

Zekmeister..
There's a description in the manual. Please follow the link in this post

[Zekmeister]

Originally Posted by Hakan

Zekmeister..
There's a description in the manual. Please follow the link in this post

Thanks for that. I'm a visual learner and I'm just trying to figure out the steps on how to solder the connections. Sorry for the confusion.

[Zekmeister]

Forgive my ignorance but do you solder the on and off switch on the board ? Please see attached.

[Hakan]

A picture from the manual below.
Pin 5 on the connector to the radar scanner shall be connected to shield by the switch.

[Zekmeister]

Originally Posted by Hakan

A picture from the manual below.
Pin 5 on the connector to the radar scanner shall be connected to shield by the switch.

Thank you so much