Anode opinions

[KelseyB]

Updates:

I couldn't find one for the end of the shaft that fit, but attached is a picture of the thinnest collar zinc I could find. What do people think about the spacing between it and cutlass bearing? Will this still allow enough water flow into the bearing?

[fstbttms]

Originally Posted by KelseyB

Updates:

I couldn't find one for the end of the shaft that fit...

What is your shaft diameter?

[Rumrace]

The company I posted if you have a reverse thread 17.5mm they will make a collar for you the collar and zinc are universal

[GordMay]

Originally Posted by KelseyB

Updates:

I couldn't find one for the end of the shaft that fit, but attached is a picture of the thinnest collar zinc I could find. What do people think about the spacing between it and cutlass bearing? Will this still allow enough water flow into the bearing?

I'd think so.
The figure, below, doesn't indicate a min/max spacing from anode to bearing, but might be of interest.