In Search of Rod Ends

[jimbunyard]

Originally Posted by Neptune's Gear

Really? 9/16 is not an unusual size. Try RBC Bearings - Unique Design Solutions for Complex Problems

Already have, read the whole thread, and get back to us when you find the specific rod end the OP was looking for, or one that would even work for his application, specifically 9/16" LH male or female, any grade SS, stud or throughbolt mount on the spherical end. Believe that may be the source for which Atoll is looking.

[atoll]

Originally Posted by jimbunyard

Already have, read the whole thread, and get back to us when you find the specific rod end the OP was looking for, or one that would even work for his application, specifically 9/16" LH male or female, any grade SS, stud or throughbolt mount on the spherical end. Believe that may be the source for which Atoll is looking.

i belive that the RH morris minor rod end should fit,my application with the 1/2" taper on the stud,and 9/16 thread on the rod

it would also have been a very common car part in the uk during the 70's-90's

https://www.ebay.com/itm/MG-MGTD-MGT...4383.l4275.c10

[geoffr]

Jimbunyard is correct - I needed one LH and one RH both 9/16" which I wasn't able to find. Now I can get what I need really easily.

atoll - from my research what Prouts had varied.. they may have been more consistent with the Elites, but I've seen a couple of different sizing on the Snowgoose (original)

Originally Posted by jimbunyard

Except in this case, where the OP wanted 9/16" LH, where the standard sizes jump from 1/2" to 5/8"...