[SOLD] Harken Mk4 #1 Roller Furler.

[Mexican Hat]

New, never installed Harken Mk4 #1 roller furler. The #1 is sized for boats in the low to mid-30's.

This is complete with everything that came in the original package, sealants, grease, fittings, screws and includes the upper and lower terminal fittings. Was bought for a Pearson Alberg 35 restoration, along with a full set of new SS rigging that was irreparably damaged before the new rigging was fitted. Original cost was almost $4,000.

Asking $2000

Will consider trades/partial trades for a watermaker or a wheel-steering autopilot. And please note that the additional turnbuckles are not included. The sections of for the stay are about 6 feet long, the rest makes a compact shipping package. Will ship at cost.

[dlclark]

What size PIN for the tack ?

[spotfire]

how many foils included?

[Mexican Hat]

The entire set is there. I haven't looked at it recently but if I remember correctly, there are 5 plus the fixed one on the stay. I'm going to my storage place tomorrow to measure something to answer another question and I can check for sure.

[spotfire]

I sent you a pm

[Mexican Hat]

Sorry for the delay, didn't get back in until late last night.

1. Hard to be certain without a micrometer but the pin appears to be the 12 (ish) mm version. I have taken a foto and will post it when I get it downloaded from my phone.
2. There are five 7 foot sections and one +- 2 foot section along with the short section fixed to the stay.

I have taken a couple of additional fotos (why do spell checks accept 'pic' but not 'foto'?)
of all the parts and will upload them as soon as I can.

[dlclark]

How long is the stay and wire diameter?

[Mexican Hat]

The stay measured 40 feet from end to end and is 8mm or 9/32 wire.